User Manual
安全与法则注意事项-英 2017-06-28-US.indd 5
2017/6/28 下午 6:05
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
If this product is not working properly, please call TPCAST customer service for instruction.
CAUTION: The product is not intended to be serviced except by TPCAST or our authorized service
providers.
About Power Box regulatory agency identifications
For regulatory identification purposes, your product is assigned a model number of AD-1
Your product’s FCC ID is 2AL8N-AD001. This FCC ID can also be found printed on the Power Box.
To ensure continued reliable and safe operation of your device, use only the accessories listed
below with your AD-1:The Battery Pack has been assigned a model number of A1271.
NOTE: This product is intended for use with a certified Class 2 Limited Power Source, rated 5
Volts DC, maximum3.1 Amp power supply unit.
FCC RF Radiation Exposure Statement:
1.
This Transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
2.
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment.
IC RF Radiation Exposure Statement:
This equipment complies with IC radiation e xposure l imits set forth for an uncontrolled
environment.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one of the following
measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio or television technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
Industry Canada Statement
Never push objects of any kind into cabinet slots or other openings in the product. Slots and
openings are provided for ventilation. These openings must not be blocked or covered.
5