User Manual
安全与法则注意事项-英 2017-06-28-US.indd 4
2017/6/28 下午 6:05
or other products (including amplifiers) that produce heat.
•
Avoid using the product after a dramatic change in temperature.
When you move the product between environments with very different temperature and/or
humidity ranges,condensation may form on or within the product. To avoid damaging the product,
allow sufficient time for the moisture to evaporate before using the product.
NOTICE: When taking the product from low-temperature conditions into a warmer environment or
from high-temperature conditions into a cooler environment, allow the product to acclimate to room
temperature before turning on power.
•
Avoid pushing objects into the product.
Never push objects of any kind into cabinet slots or other openings in the product. Slots and
openings areprovided for ventilation. These openings must not be blocked or covered.
•
Adjust the volume.
Turn down the volume before using headphones or other audio devices.
•
Cleaning the product.
Unplug the product from its power source before cleaning. Use a damp cloth for cleaning, but
NEVER use water to clean the product. Clean and dry skin that regularly comes in contact with
the headset. If there is any itching, eczema, swelling, irritation of the skin, or you experience
any discomfort, please discontinue use and consult your physician.
About PC Transmitter regulatory agency identifications
For regulatory identification purposes, your product is assigned a model number of TX-1.
Your product’s FCC ID is 2AL8N-TX001. This FCC ID can also be found printed on thePC
Transmitter.
To ensure continued reliable and safe operation of your device, use only the accessories listed
below with your TX-1:
NOTE: This product is intended for use with a certified Class 2 Limited Power Source, rated 12
Volts DC, maximum1 Amp power supply unit.
RF exposure:
To comply with the IC RF exposure compliance requirements, this device and its antenna must
not be co-located or operating in conjunction with any other antenna or transmitter.
This equipment should be installed and operated with a minimum distance of 20 centimeters
between the radiator and your body.
About HMD Receiver regulatory agency identifications
For regulatory identification purposes, your product is assigned a model number of RX-1.
Your product’s FCC ID is 2AL8N-RX001. This FCC ID can also be found printed on the HMD
Receiver.
NOTE: This product is intended for use with a certified Class 2 Limited Power Source, rated 5
Volts DC, maximum1.5 Amp power supply unit.
RF exposure:
To comply with the IC RF exposure compliance requirements, this device and its antenna must
not be co-locatedor operating in conjunction with any other antenna or transmitter.
FCC RF Radiation Exposure Statement:
1.
This Transmitter must not be co-located or operating in conjunction with any other antenna
or transmitter.
2.
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment.
IC RF Radiation Exposure Statement:
This equipment complies with IC radiation e xposure l imits set forth for an uncontrolled
environment.
4