Operating Instructions

SMARTRO X50 has 8 probe rings (including red, yellow, green,
blue, 2 rings for each color).
Always attach probe rings by sliding them over the probe tip.
Attempting to attach probe rings by sliding them over the probe
jack will cause them to stretch and loosen.
First Probe Ring:
Step 1:
Slide the first of the two matching probe rings over the
probe tip.
Second Probe Ring:
Step 1:
Holding the second probe ring, slide probe ring over the
probe.
Step 2:
Roll the probe ring over the PEEK of the probe.
Step 3:
Place the probe ring at the point where the metal spring
and the PEEK meet.
Step 2:
Roll the probe ring over the metal springs of the probe.
Step 3:
Slide the probe ring down the cable until it is over the
metal springs of the probe jack. There will be a slight groove to
hold the probe ring in place.
4. Probe Ring Installation Instructions
13 14