User's Manual

Click the gear button to modify print profile for the

height range.

Use chain button to link or unlink from the part profile.

Use cross button to delete the child profile.

Setting child profile is same setting of main profile. However some settings are not available

in child profiles, eg. Layer thickenss. Child profile allow user to adjust print speed,

temperature, extrusion scale, infill density, and etc for a particular vertical section of the

part

2. Optimize on X-Y plane

Use child model could allow user to optimize the part on another dimension.

1. Click “+” button add child

model.

a cylinder is added as a child model for the cube.

2. Select the type of child

model and define the

dimensions.

For the child model, user could define the property as union, subtract or select a infill

density.

Union: fuse child model into

the main model.

Subtract: child model is

subtracted from the main

model.

Infill: modify the infill

percentage of at the

overlapped region.

End

point

Start

point

Height

range