User's Manual

51
Profile/Fill Overlap
N/A
Overlap ratio between Perimeter and Infill
Bottom Overlap
N/A
Overlap ratio between Perimeter and infill for the bottom layer
8.6.3.Special
Special Options
Fill Mode
N/A
Fill = Perimeter+infill+top/bottom
Shell = Perimeter+top/bottom (no infill)
Vase = Perimeter only (no infill, no top/bottom)
Perimeter Gap
mm
Tolerance
mm
+0.1 = X and Y plane both increase 0.1mm in size
Fuse Gap
mm
Radius for small gap to be fused.
Thin Wall
Features that are not printable due to to small/thin will be retained and
force printed. Dimensional accrucy may be compromised when checked but
all features are preserved.
Hole Shrink
(only applied to vertical holes on a part, expand small holes to counter the hole shrink effect)