User's Manual

45
Inner
Perimeter
(Green)
Support
8.6.1. Slicer Settings
Term
Unit
Description
Quality
Layer Thickness
mm
Layer thickness of print, the bigger the thickness the faster the print speed
and lower the print quality.
Max. Layer Thickness
mm
Adaptive layers is to automatically adjust layer thickness base on the
overhang angle. Set the largest layer thickness for adaptive layers.
Adaptive ratio
N/A
The bigger the adaptive ratio, the more discrete shift from thin to thick
layers through overhangs. Overall the algorithm will more inclined to use
thicker layers when the ratio increases.
Layer thick = Max (normal thick, min( thick, normal thick*tan(angle) ))*ratio
Custom
N/A
Custom layer thickness. Allow user to define specific layer thickness for
define height range:
Syntax: [start height, end height]layer thickness
Eg. [0,10]1.0[25,35]1.0
Bottom Layers
Top Layers
Infill
Support Top
Layers
Outter Perimeter (Blue)