User's Manual

40
3. Point
support
Support the “Tip” features
Support Angle
The overhang angle threshold for support, overhangs less than this angle
will not have support generated.
Top Layer
This determine number of interface layers between the support
structure and the surface being supported. Increase the layer may make
the support easier to remove but increase print time.
Top Lift
Determine the height the support will “wrap” above the layer of the
point or edge features.
Draft Angle
Adding draft angle will make the base of the support to be wider than
the top, this increase the stability of the support column.
Support
Parameters
Support List
View Options
Support Preview