User's Manual

31
7.2 Set Nozzle Height through Touchscreen, please refer to page xxx.
7.3 Setup Nozzle Height Value through Wand (computer hosted)
1. Connect printer to computer, open UP Studio 3.0 and click the “Print” button
to open “Wand”. Click “Nozzle Height” button, the print head will move the position
that is near the platform.
2. Use the height detector included to confirm the nozzle height value.
User need to put the sensor pad of the detector under the nozzle and then use + / - buttons
to adjust the nozzle to touch the sensor until the sensor give a buzz sound.
When the nozzle height is determined by the sensor, click “Apply Height” to update the
nozzle height value.