User's Manual

19
Insert PLA filament here.
(main material)
To install the filament, please following the instruction below:
1. Remove the vacuumed bag of PLA filament.
2. Find the end of the filament, and use pliers to make a clean cut of the end.
3. Open the filamentbay,and the BLUE colored (for main material) filament entrance
of the feeding tube.Insert PLA filament into the guiding tube, you should able to feel
the filament triggered mechanical switch (filament sensor) at the entrance.
4. Keep feeding the filament until the end of the filament sticks out from the other
end of the guiding tube (You can open the top lid, and make sure the filament sticks
out).
Go to Touchscreen
6. Press Material
7. Press “Filament 1”Material Button until it shows
“PLA” and press “+” button to single the weight of
material to 500g
7. Press the “ ” button to extrude material
8. Hold and gently push the filament into the
extruder entrance marked”1” (Blue Color) until it
feed into the extruder by its motor.