Users Manual Part 1

Draft Angle

Adding draft angle will make the base of the support to be wider

than the top, this increase the stability of the support column.

Draft Angle = 0

Draft Angle = 50

Min. Area

Area threshold of the support structure, overhang surface with

area less then the threshold will not be supported.

Min. Length

Length threshold for the edge support. Edges shorter than the

threshold will not be supported.

Support List

Enable：turn support on or off.

View: hide/show support, not affecting its status.

Remove: remove support from list, not affecting its status.

Support Filter

Filter allow user to setup conditions to only show a subset of supports in the

support list. This conditions could be:

1. Support Type

2. Support Status

3. Supported Surface Area

4. Location on the XYZ plane.