User's Manual

Load and print the

calibration model:

C:\ProgramFiles\UP\

Example\Calibrate96.UP3

Calibration for the Correct Dimension

If prints are too big or too small or skewed, user could re-calibrate the printer to

print in correct dimension. The method is to print a calibration model, measure

its dimension and feedback to the software.

Measure the printed

model accroding the

calibration panel.

Input the measured

values into the software

and nish the calibration.

Open: 3D Print - Calibrate

This will open the calibration

panel.

Hit "Reset" button to

revert the value back to

default,make sure the

upper panel dispaly:

XY:0.00 Deg/XZ:0.00 Deg