User's Manual

11
Coarse Manual Platform Leveling
Other Options of the Maintenance Menu:
Withdraw: the printer heat up and withdraw lament from the print
head.
New Spool: to tell the software what is the current lament type, the
lament that used must match here.
Heat Table 1 hr: preheat table for 1 hour.
To Bottom: move the platform to the bottom.
Set Nozzle Height: set the current platform height as nozzle height.
Usually you do not need to adjust the
platform manually. This is only necessary
if automatic leveling were unable to
effectively level the platform.
There are 3 screws under the platform
of UP BOX. Two screws in front and
one screw under the platform at the
back. These screws can be fastened or
loosened to adjust the leveling of the
platform.
In "3D Print" - "Maintainance" window,
user can move the print head to 5
difference postions on the platform. User
can also use "To" button to move the print
platform to a particular height.
First move print head to the center of the
platform and move the platform to almost
touching the nozzle (eg. nozzle height).
Use a piece of paper to determine the
correct platform height
Try to move the paper and feel the drag.
When one can feel the resistance from the
nozzle, base on the right side diagram.
Make sure you can feel similar drags at
all 5 positions by moving the print and
adjusting the screws while the platform
height is xed.
Platform too high,
nozzle is pinning
paper onto the
platform, Lower the
platfrom slightly.
Just right,could feel
some resistance
when moving the
paper.
Platform too low,
no resistance at all
when moving paper,
raise the platform
slightly.