User's Manual

3.Operation
UP Plus 2 User Manual 42
5. Model Removal
1. When the model has finished printing, the printer will beep, and the nozzle and
platform stop heating.
2. Remove the printer platform from the printer by removing the 2 screws at the
bottom of the platform.
3. Gently slide the spatula under the model and slowly wiggle it back and forth to
pry loose the model. Remember to use gloves as the platform and model may still
be hot.
TIP: It is very strongly recommended that you remove the platform from the printer
before removing the parts. If you do not, you are very likely to eventually bend
the entire platform assembly so that it is no longer at right angle to the printer
head. For an easier way to remove the platform see the Tips & Tricks section of
the manual for instructions on printing little knobs to glue onto the platform
screws that make it much easier to remove without tools.
TIP: The model is easier to remove from the printer when it is still hot. If you want to