User's Manual

3.Operation
UP Plus 2 User Manual 36
The part has an outer wall thickness of solid plastic (about
1.5mm), but its interior is filled with a large spaced scaffold
structure. On previous software version this was referred to as
―Big hole‖
Support Options
Dense: This represents how many layers of ‗solid‘ (dense) material form part of the
support structure directly beneath the model.
Angle: Angle at which support material gets used. For example if 10° is used, support
material only gets used if angle of surface is greater than 10° from horizontal (so
support material is almost not used unless there is a direct overhang), If set to 50° than
support material is used for any surface is greater than 50° away from horizontal.