User's Manual

3.Operation
UP Plus 2 User Manual 11
The below picture is an alternative filament holder. The stl file can be downloaded at the
―download‖ section of www.pp3dp.com.
3. Install the filament supplier. Unscrew the short M3 screw (M3X5) from the printer,
and then fix the filament supplier with a long M3 screw (M3X8). Please note that the
filament supplier should lock onto the printer‘s corner.
4. Install the extruder cable (14-pin). You can see a 14-pin socket on the top of
extruder. Connect the plug into the socket, and put the upper lid back on.