User's Manual Part 1

Click print button to open
the print interface
Set Layer Thickness
Select Infill Type
Select Print Quality/Speed
Advanced Options
Shell: No infill,
normal wall.
Surface: No
top and bottom
layers, no infill,
single perimeter.
Hollow Big Hole Loose Fill Solid Fill
Print a Model
Make sure printer is connected to computer throug USB or WIFI ( go to page xxx for details
about WIFI setting)and loaded a model.
When the UP software is slicing or sending data to the printer—progress dis- played on the
status bar on top of the software interface —do not unplug the USB cable as this will disrupt
the data transfer and result in a print failure. The USB cable can be unplugged after the data
transfer is finished.