User's Manual Part 1

Safety Precautions

1\ Insert the filament from the spool into guiding tube, arrange the guiding tube as shown in pre-

vious page. Press the Material button on the touch screen.

4\ Gently insert the filament into the small

hole on the print head. The filament will be

fed into the print head automatically when

it reaches the extruder gear inside the print

head.

5\ Check the nozzle for plastic extrusion. If plastic is

coming out from the nozzle, that means the filament is

loading correctly and the printer is ready for printing. (The

extrusion will stop automat- ically.)

6\ Finally insert the guiding the tube in to

the filament entrance and press the tube

into the holding clip on the print head

mount.

2\ Choose the printing material as ABS by press the Wheel button to switch between different

mate- rials input the filament weight by using the

+/- buttons.

3\ Click "Extrude." The print head will start to heat up, within five minutes. Its temperature will reach

260°C, then the printer will buzz and the print head will start to extrude.

Guiding Tube

Filament

Extrusion

Guiding Tube

Press the guiding tube

into the clamp