User's Manual
Table Of Contents
- 1. FEATURES
- 2. DESCRIPTION
- 3. PINNING INFORMATION
- 4. Communication Protocol
- 4.1 Communication Setting
- 4.2 Communication Format
- 4.3 Command Overview
- 4-4. Command List
- 4-4-1 System Function Command
- 4-4-2 ISO14443A - Mifare Function Command
- 4-4-2-1. Request(Card A)
- 4-4-2-2. Anticollision(Card A)
- 4-4-2-3. Select card (Card A)
- 4-4-2-4. Halt (Card A)
- 4-4-2-5. Authenticate
- 4-4-2-6. Read block
- 4-4-2-7. Write block
- 4-4-2-8. Initialize electronic purse
- 4-4-2-9. Read purse value
- 4-4-2-10. Decrease purse value (including Transfer)
- 4-4-2-11. Increase purse value (including Transfer)
- 4-4-2-12. Restore purse value
- 4-4-2-13. Transfer
- 4-4-2-14. Get ATS of CPU A
- 4-4-2-15. Exchange data between PICC and PCD according with T = CL protocol
- 4-4-2-16. Ultralight card Anticoll and Select
- 4-4-2-17. Write a page of data into ultralight card
- 4-4-2-18. Authenticate password of Ultralight_C
- 4-4-2-19. Change password of Ultralight_C
- 4-4-2-20. SHC1102 card check password
- 4-4-2-21. Read data block of SHC1102 card
- 4-4-2-22. Write data block of SHC1102 card
- 4-4-2-23. Request DESFire and reset
- 4-4-2-24. Get version of Ntag213/216
- 4-4-2-25. Read page of data of Ntag213/216
- 4-4-2-26. Fast read page of data of Ntag213/216
- 4-4-2-27. Get NFC counter of Ntag213/216
- 4-4-2-28. Authenticate password of Ntag213/216
- 4-4-3 NFC Function Command
Federal Communications Commission (FCC) Interference Statement
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE
FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL
INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
NOTE: THE GRANTEE IS NOT RESPONSIBLE FOR ANY CHANGES OR MODIFICATIONS NOT
EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE. SUCH
MODIFICATIONS COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
For additional hosts other than the specific host originally granted with a limited module, a Class II
permissive change is required on the module grant to register the additional host as a specific host also
approved with the module. The host must meet the necessary requirements to satisfy the module limiting
conditions: shield and power supply regulation.
The module is limited to OEM installation ONLY. The OEM integrator is responsible for ensuring the end-
user has no manual instructions to remove or install module