User's Manual

Stronglink
2 / 2
There is firmware in the 8051 chip realizing UART master process.
3. How it works
T060 is a UART master device and can send commands what SL060 module can recognize.
After power on, T060 starts to send the command to SL060 via UART. After sending, it waits for
the response until timeout (About 2 seconds).
The commands T060 sends,
1) Select card;
2) Authenticate Sector 1 Block 0(Block 4);
3) Write this Block;
4) Read this block;
All the commands can be referred in the <SL060 User Manual>.