User's Manual
Table Of Contents
- Main Features
- PINNING INFORMATION
- Device Operation
- Command Description
- 4-2. Command Overview
- 4-3. Command List
- 4-3-1. Select Mifare card
- 4-3-2. Login to a sector
- 4-3-3. Download Key into SL030
- 4-3-4. Login sector via stored key
- 4-3-5. Read a data block
- 4-3-6. Write a data block
- 4-3-7. Read a value block
- 4-3-8. Initialize a value block
- 4-3-9. Write master key (KeyA)
- 4-3-10. Increment value
- 4-3-11. Decrement value
- 4-3-12. Copy value
- 4-3-13. Read a data page (UltraLight & NTAG203)
- 4-3-14. Write a data Page (UltraLight & NTAG203)
- 4-3-15. Request for Answer to Select (ISO14443-4)
- 4-3-16. Exchange Transparent Data (T = CL)
- 4-3-17. LED Control
- 4-3-18. Power Down
- 4-3-19. Write Perso
- 4-3-20. Commit Perso
- 4-3-21. Get firmware version
- 4-3-22. Turn on/off Auto-detection
- 4-3. Command List
- Differences from previous version
Federal Communications Commission (FCC) Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one of
the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
RF exposure warning
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment.
This product may not be collocated or operated in conjunction with any other antenna or transmitter.