User's Manual

42
The VibraRise module is jammed. Clear blockages and move the
robot to a new location and restart.
Error 27: VibraRise Module Jammed.
The robot may be on a carpet. Move it from the carpeted area.
If this is an error, wipe the carpet sensor and restart.
Error 28: Carpet Detected.
No-Go Zone or Invisible Wall Detected.
Remove the virtual barrier or move the robot from the current posi-
tion and restart.
The robot cannot cross carpets when mopping. To continue, manual-
ly place the robot on the other side of the carpet and restart.
Unable to Cross Carpet.
Malfunction due to an internal error. Reset the system.Internal Error.
Note: A system reset may not resolve all problems.
Errors
Check the lter. If wet, use a dry one. If dry, clean it and
try again.
The lter is not completely dry. Dry the lter for at least 24 hours.
The lter may also be blocked and require cleaning. If the problem
persists, replace the lter.
If an error occurs while the robot is cleaning, the power indicator will ash red quickly, and a voice alert will sound. Refer to the following table
for Troubleshooting.
Error Solution