User's Manual

The robot will clean the areas selected in the app.

Charging

The robot will return to the charging dock automatically after

nishing. If it is paused, press the

button to send it to the

charging dock. The power indicator will ash slowly as the robot

charges.

Note: If the robot cannot nd the charging dock, it will return to the most recent starting

location. Place the robot on the charging dock manually to recharge.

Error

If an error occurs, the power indicator ashes red quickly, and a

voice alert sounds. See Troubleshooting for solutions.

Note:

•

The robot will automatically enter Sleep mode if left in an error state for over 10 minutes.

•

Placing the robot on the charging dock in an error state will stop the current cleanup.

System Reset

If the robot does not respond to button presses or cannot be

turned o, reset the system. The robot will then restart.

Note: After a system reset, cleaning schedules, WiFi, and other settings will be restored to

factory settings.

Restore Factory Settings

If the robot is not functioning after a system reset, turn it on and

press the

button. Then press and hold the Reset button until

you hear the "Restoring the initial version" voice prompt. The

robot will then be restored to factory settings.

Zone Cleaning

The robot will clean the Zone(s) drawn in-app.

Note: The robot may enter unselected areas during cleaning. Clear obstacles from the

ground around the selected rooms as the robot may enter these areas.

Selective Room Cleaning

Note:

•

Map Saving mode must be switched on, and a full clean completed before this function can

be used.

•

The robot may enter unselected areas during cleaning. Clear obstacles from the ground

around the selected rooms as the robot may enter these areas.

Instructions