User's Manual
25
On/O
Press and hold the button to turn on the robot. The power in-
dicator will turn on, and the robot will enter standby mode. Press
and hold the
button to turn o the robot and end the current
cleaning cycle.
Note: The robot cannot be turned o when it is charging.
Note:
•
Cleaning cannot start if the battery level is too low. Allow the robot to charge before start-
ing cleanup.
•
Before cleaning, tidy cables (including the charging dock power cable) and fragile items
from the oor. Loose wires and objects may get caught in the robot, resulting in disconnec-
tion or damage to wires and property.
•
If cleaning is completed in less than 10 minutes, the area will be cleaned twice.
•
If the battery runs low during the clean, the robot will automatically return to the charging
dock to top up and continue where it left o.
•
If the mop bracket is attached, the robot will lift the mop to clean carpeted areas. You can
choose to avoid carpeted areas in the app.
Zone 1 – Cleaned
Zone 4 – Next Zone
Zone 2 – Cleaned
Zone 3 – In Progress
Start Cleaning
Press the button to start cleaning. The robot will plan its route
based on its scan of the room. It then splits each room into
squares, cleaning the edges of the square rst before covering the
inside in a zigzag pattern. Afterward, it moves to the next square
until every zone in every room has been eciently covered.
Mode Setting
Use the app to adjust suction power and water ow when
mopping.
Instructions