Users Manual Part 2

20
Main Brush and Mop Roller
1. Turn over the robot, press the roller cover latches to open them, and remove the
main brush and/or mop roller.
3. Remove any entangled hair or dirt in the main brush and mop roller, and then
reinstall them.
2. Pull out the main brush and mop roller bearing. Remove the main brush and
mop roller caps by rotating them in the indicated unlock direction. Clean the
caps and reinstall them in the indicated lock direction.
Routine Maintenance
Note:
•
If there is a large amount of hair, or hair is tightly entangled, remove it carefully to avoid damage to the main
brush. It is recommended to use scissors to cut the hair.
•
It is recommended to wipe the main brush with a wet cloth. If the main brush is wet, air-dry it away from direct
sunlight.
•
Do not use corrosive cleaning uid or disinfectant to clean the main brush.
Side Brush
1. Unscrew the side brush screw.
2. Remove and clean the side brush. Reinstall the brush and tight-
en the screw.
Omni-Directional Wheel
1. Use a tool, such as small screwdriver, to pry out the axle and take out the wheel.
2. Clean and rinse the wheel and the axle with water to remove any hair and dirt.
3. Air-dry, reinstall, and press the wheel and axle back in place.
Note: The omni-directional wheel bracket cannot be removed.