Users Manual

Auto Focus

After the device turns on, it performs auto focus for a few seconds to adjust the image

for a clear resolution. To perform auto focus again, tilt the device forward about 30°and

stand it up straight again.

Hard Reset

When the device crashes or does not work normally, press and hold the power button

for 15 seconds to hard reset the device.

FCC Warnning:

Any Changes or modiﬁcations not expressly approved by the party responsible for compli-

ance could void the user's authority to operate the equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions:

(1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause

undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio commu-

nications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment oﬀ and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit diﬀerent from that to which the receiver

is connected.

-Consult the dealer or an experienced radio/TV technician for help.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled

environment. This equipment should be installed and operated with minimum distance

20cm between the radiator & your body.

Power-on/Power-oﬀ/Screen-oﬀ

Power-On: When the power is on, press and hold the power button for 3 seconds to

turn it on.

Power-Oﬀ: Press and hold the power button for 1.5 seconds and select Power Oﬀ in the

shutdown menu that pops up.

Screen-Oﬀ: When the screen is on, press the power button brieﬂy to turn oﬀ the screen

display.