User's Guide

AXIS STUDIO USER GUIDE 6
5. Open the properties of the Remote NDIS, and open the IPV4 settings.
6. Set the following IPV4 properties:
IP Address: 192.168.1.200* ( range: 192.168.1-192.168.1.240 )
Subnet Mask: 255.255.255.0
7. Confirm settings and exit all Network Property windows.
8. Restart Transceiver by disconnecting and reconnecting USB cable from the Transceiver.
9. Open Axis Studio software*
* If 192.168.1.200 is taken by an existing Network Adapter then choose one from the provided IP range.
Network Adapters cannot have conflicting IP addresses.
*If the transceiver is not shown in the software, please check USB transceiver link troubleshooting
Ethernet Connection
If you are using two or more transceivers simultaneously, use an unmanaged switch and a DHCP enabled
router to synchronize the transceivers data.
1. Connect an Ethernet cable from the PC to the router.
2. Connect an Ethernet cable from the router to the switch.
3. Connect Ethernet cables from the transceivers to the switch.
4. Once the transceivers have been connected successfully they show now appear in the software.