Product Description

5
One end of the network cable is connected to the POE interface of the Gateway, and the other
end is connected to the OUT port of the POE power supply.
Ensure that nodes are working within the Gateway coverage.
If you need to view the gateway location information or use the ClassB function, make sure
that the GPS antenna is unobstructed outside.
By default, the Gateway uses DHCP to obtain the network address.
If there are no special requirements (such as using an internal fixed IP address), the gateway
enters the normal operation mode when it is powered on. The method for verifying whether the
gateway is working properly is as follows.
( 1 ) Turn on POE power supply
( 2 ) Add a gateway to the NMS platform to view the gateway status and upstream data. For more
information about how to use the NMS platform, see the link below. 《 UG_SW 01 -NMS platform
instructions 》
Note:
Standard Edition: only ThinkOne servers can be accessed.
General edition: it can access servers of various manufacturers that meet the LoRaWAN
standard. It supports packet forwarder uplink protocol format and TTN and LORIOT
●
3 . 3 Environment preparation
●
●
3 . 4 Start using
4 . Ordering information
4 . 1 order information table
●
●
GDO 318 ANAS 923 -N 8 -channel Ethernet, AS 923 Standard edition
GDO 318 ANAS 923 -L 8 -channel Ethernet, AS 923 Alibaba edition
GDO 318 ANAS 923 -G 8 -channel Ethernet, AS 923 Universal Edition
GDO 318 ANEU 868 -N 8 -channel Ethernet, EU 868 Standard edition
GDO 318 ANEU 868 -G 8 -channel Ethernet, EU 868 Universal Edition
GDO 318 ANKR 920 -N 8 -channel Ethernet, KR 920 Standard edition
GDO 318 ANKR 920 -G 8 -channel Ethernet, KR 920 Universal Edition