User's Manual

INSTALLATION
BEFORE YOU BEIGIN
1. Make sure that power to all the devices you will be connecting up have been turned off.
2. To prevent damage to your installation, make sure that all devices on the installation are properly grounded.
SINGLE STAGE INSTALLATION
To set up yourKS-3108 / KS-3116 installation, do the following:
1. Plug your PS/2 / USB keyboard, PS/2 / USB mouse and monitor into the console port section located on the
unit’s rear panel.
2. Plug one end of the CAT5 UTP into the available computer port on the switch.
3. Plug the other end of the CAT5 UTP into the RJ45 port on the matching dongle. Connect the dongle to the
computer.
4. Repeat step 2-4 for any other computers you are connecting up
5. Plug the power adapter cable into the switch’s power jack, then plug the power adapter into an AC power
source.
This completes the single stage installation, and you can turn on the power to the computers.
NOTE: TheKS-3108 / KS-3116 initially links to computer connected to the first Computer port.
ILLUSTRATION: