User's Manual

Video 4 x HDB-15 male (blue) 8 x HDB-15 male

(blue)

16 x HDB-15 male (blue)

On Line 4 8 16 LEDs

Selected 4 8 16

Video resolution 1600 x 900

Power

DC5V, 400mW

Operating temperature -10˚C~50˚C

Storage temperature -20˚C~60˚C

Housing Metal

Weight 0.8 Kg

Dimensions(L x W x H ) 432 x 155 x 44 mm

SAFE GUIDE

 Please follow the directions below when installing, using and maintaining it in order to guarantee the

device to work well.

 When installing and operating the device, please make sure proper power supply first, and then do other

operations after it is initialized.

 As signal and power transfer need custom cable, please use matched cable, unmatched cable may cause

system work improperly or even damage the device.

 Keep airy during operating to prevent high temperature.

 Keep the device away from working long in wet environment to prevent short circuit.

 Please do not open the device without permission of professionals.

FCC NOTE:

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions:(1)this device may not cause harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the

following measures:

-- Reorient or relocate the receiving antenna

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help.

The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to

this equipment. Such modifications could void the user's authority to operate the equipment.