User's Manual

36
Description
For recording significance of each virtual IP address
rule
N/A
3.4.6 DMZ
After mapping all ports, extranet PC can access to all ports of internal device by DMZ settings.
From the navigation tree, select Firewall >> DMZ, then enter the “DMZ” page.
Table 3-4-6-1 Firewall - DMZ Parameters
DMZ
Function description: Configure DMZ settings.
Parameters
Description
Default
Enable DMZ
Check to enable the DMZ.
Disable
DMZ Host
Set address of DMZ Host
N/A
Range of Source Address
Enter range of source address
N/A
Interface
Select interface as DMZ: CELLULAR/WAN/VPN
Interface
N/A
3.4.7 MAC-IP Binding
If the default process in the basic setting of firewall is disabled, only hosts specified in MAC-IP can
have an access to outer net.
From the navigation tree, select Firewall >> MAC-IP Binding, then enter the “MAC-IP Binding”
page.
Table 3-4-7 Firewall - MAC-IP Binding Parameters
MAC-IP Binding (at most 20 MAC-IP Bindings can be set)
Function description: Configure MAC-IP parameters.
Parameters
Description
Default
MAC Address
Set the binding MAC address
00:00:00:00:00:00
IP Address
Set the binding MAC address
192. 168. 2. 2
Description
For recording the significance of each MAC-IP
binding configuration
N/A
3.5 QoS
Some applications bring convenience to users, but they also take up a lot of network bandwidth.
To ensure all LAN users can normally get access to network resources, IP traffic control function