User's Manual

32
Based on types, the alarms are classified into system alarms and port alarms.
 System alarm: reported when a system or environment error occurs.
 Port alarm: reported when a network port error occurs.
In the Alarm Manager interface, you can perform the following operations:
 Select your interested alarm types in the "Alarm Input" area.
 Set the alarm notification method of the console in the "Alarm Output" area. The default
output method is log recording. After this function is configured, the system sends
generated alarms to the console.
Choose Services >> Alarm Manager to go to the "Alarm Manager" page.
Table 3-32 Alarm Manager Parameters
Alarm Manager
Function: Set your interested alarm types.
Parameters
Description
Default
System Service Fault
Click to enable the system service fault
alarming.
Disabled
Memory Low
Click to enable the memory insufficiency
alarming.
Disabled
WAN Link-Up/Down
Click to enable the link up/down alarming
of the WAN port.
Disabled
LAN Link-Up/Down
Click to enable the link up/down alarming
of LAN ports.
Disabled
Dialup Up/Down
Click to enable the up/down alarming of
the dialing interface.
Disabled
Traffic Alarm
Click to enable the traffic alarming.
Disabled
Traffic Disconnect Alarm
Click to enable the traffic termination
alarming.
Disabled
SIM/UIM Card Fault
Click to enable the SIM/UIM card fault
alarming.
Disabled
Signal Quality Fault
Click to enable the signal quality alarming.
Disabled
Console
Click to enable alarm notification of the
console.
Disabled