User's Manual

30
Table 3-28 SNMP Trap Configuration Parameters
Parameters
Description
Default
Trap SigLevel
Set the trap signal threshold. When this threshold is reached, the
agent outputs logs to the NMS.
10
Destination
Address
Fill in the IP address of the NMS.
None
Security Name
Fill in the community name for SNMPv1 or SNMPv2c, and fill in
the user name for SNMPv3. The length is 1 to 32 characters.
None
UDP Port
Fill in the UDP port number, ranging from 1 to 65535.
162
3.3.7 DTU
From navigation tree, select "Service>>DTU" menu, then enter “DTU” page.
Table 3-3-5 DTU 1 DTU Parameters
DTU
Function description: Realize general functions.
Parameters
Description
Default
Enable
Click to enable backup DTU function
Disable
DTU Protocol
Select DTU protocol: Transparent transmission,
DC protocol transmission, Modbus network
bridge, virtual serial port, WP protocol, WN
protocol, Trap+Poll
Transparent
Protocol
UDP/TCP protocol
UDP
Mode
Set DTU as a client.
Client
Serial Frame Interval
Set the serial frame interval.
100 ms
Serial Buffer Frames
Set the number of serial buffer frames.
4
Multi-Server Policy
Set parallel or polling
Parallel
Min. Reconnect
Interval
Set the min. reconnect interval
15 s
Max. Reconnect
Interval
Set the max. reconnect interval
180 s
DTU ID
Set DTU ID.
N/A
Source address
Set the Source IP.
N/A
Report DTU ID interval
Set report of DTU ID interval
0 s
Multi-Server
Set server address and port
N/A
3.3.8 SMS
SMS permits message-based reboot and manual dialing. Configure Permit to Phone Number and
click <Apply and Save>. After that you can send “reboot” command to restart the device or send