User's Manual

53
Table 3-8-2 Smart Report Parameters
Status Report
Function description: Monitor device status and Report to cloud platform
Parameters Description Default
Status Report Enable status upload service Disable
Server Set server name N/A
Server Port Set server port N/A
Username Set user name test
User Password Set user password test
Status info Upload Interval Time of upload interval 60 second
Protocol Monitor protocol type TCP
Log Enable Enable log Close
HTTP API Enable HTTP API OPEN
Show router report
args setting
Setting status upload message Disable
Router hostname show router name Disable
Router serial number Show router serial number Enable
Cellular ip address Show cellular ip address Enable
Signal strength Show signal strength Enable
Terminal ID Show terminal ID Disable
MNC、MCC、Cell ID、LAC
Uptime
Show MNC、 MCC、 Cell ID 、 LAC
Uptime
Disable
Current firmware version Show current firmware version Disable
Timestamp Show timestamp Disable
Advice config Set advance config N/A
3.8.3 Smart-EMS
Select Application >> Smart-EMS, then enter the “Smart-EMS” page. You can set the
configuration about Smart-EMS.
Table 3-8-3 Smart-EMS Parameters
Smart-EMS
Function description: configure parameters for docking intelligent Smart-EMS cloud platform
Parameters Description Default
Server URL Fill in server address N/A
Username Fill in user name N/A
Password Fill in user password N/A
Contact interval Set time of contacting interval N/A
Send running config Enable send run configuration Disable