User's Manual

34
Table 3-3-10 Alarm Manager Parameters
Alarm Manager
Function: Set your interested alarm types.
Parameters Description Default
System Service Fault Click to enable the system
service fault
alarming.
Disabled
Memory Low
Click to enable the memory insufficiency
alarming.
Disabled
WAN Link -Up/Down Click to enable the link up/down alarming
of the WAN port.
Disabled
LAN Link-Up/Down Click to enable the link up/down alarming
of LAN ports.
Disabled
Dialup Up/Down Click to enable the up/down alarming of the
dialing interface.
Disabled
Traffic Alarm Click to enable the traffic alarming. Disabled
Traffic Disconnect Alarm
Click to enable the traffic termination
alarming.
Disabled
SIM/UIM Card Fault Click to enable the SIM/UIM card fault
alarming.
Disabled
Signal Quality Fault Click to enable the signal quality alarming. Disabled
Console Click to enable alarm notification of the
console.
Disabled
3.4 FIREWALL
The firewall function of the router implements corresponding control to data flow at entry
direction (from Internet to local area network) and exit direction (from local area network to
Internet) according to the content features of message (such as: protocol style, source/destination
IP address, etc. ) and ensures safe operation of router and host in local area network.
Settings of firewall include basic setup, access control, filtering, port mapping, virtual IP mapping,
DMZ setup and MAC-IP Binding.