User's Manual

32
3.3.7 SNMP Trap
SNMP trap is a type of entrance. When this entrance is reached, the SNMP managed devices
actively notify the NMS, instead of waiting for the polling of NMS. On an SNMP-enabled
network, the agents on managed devices can report errors to the NMS anytime, without the need
of waiting for the polling of NMS. The errors are reported to the NMS through traps. Click
"Service>>SNMP Trap" menu to configure.
Table 3-3-7 SNMP Trap Configuration Parameters
Parameters Description Default
Trap SigLevel Set the trap signal threshold. When this threshold is reached, the
agent outputs logs to the NMS.
10
Destination
Address
Fill in the IP address of the NMS. None
Security Name
Fill in the community name for SNMPv1 or SNMPv2c, and fill in
the user name for SNMPv3. The length is 1 to 32 characters.
None
UDP Port Fill in the UDP port number, ranging from 1 to 65535. 162
3.3.8 SMS
SMS permits message-based reboot and manual dialing. Configure Permit to Phone Number and
click <Apply and Save>. After that you can send “reboot” command to restart the device or send
custom connection or disconnection command to redial or disconnect the device.
From navigation tree, select "Service>>SMS" menu, then enter “SMS” page.
Table 3-3-8 SMS Parameters
Short message
Function description: Configuration SMS function to manage the router in the form of SMS.
Parameters Description Default
Enable Click to enable backup DTU function Disable
Status Query
Users define the English query instruction to inquire current
working status of the router.
N/A
Reboot Users define the English query instruction to reboot the router. N/A
SMS Access Control
Default Policy Select the manner of access processing. Accept
Phone Number Fill in accessible mobile number N/A
Action Accept or block Accept
Description Describe SMS control.