User's Manual

23
Table 3-2-8 VRRP Parameters
VRRP
Function description: Configure parameters of VRRP.
Parameters Description Default
Enable VRRP-I Click to enable VRRP function Disable
Group ID Select ID of router group (range: 1-255) 1
Priority Select a priority (range: 1-254)
20 (the larger the numerical
value, the higher the priority)
Advertisement
Interval
Set an advertisement interval. 60 s
Virtual IP Set a virtual IP N/A
Authentication
method
Select "None" or Password type
None (a password is needed
when password type is
selected)
Monitor Set monitor N/A
VRRP-II Set as above Disable
3.2.9 IP Passthrough
IP penetration function distributes the address obtained by WAN port to the device at the lower
end of LAN port. When external access to the router downstream devices the router transmits data
to the downstream device. Click "Network >>IP Passthrough" menu, then enter “IP Passthrough”
page.
Table 3-2-9 IP Passthrough Parameters
IP Passthrough
Function description: LAN port device to obtain WAN port address, used for external access to
router downstream devices.
Parameters Description Default
IP Passthrough Enable IP Passthrough Disable
Mode
Select work mode（DHCP Dynamic/DHCP fix MAC)
DHCP
Dynamic
FIX MAC Set fix MAC address
00：00：00：
00：00：00
DHCP lease Set DHCP lease time and reacquired after expiration 120S