User's Manual

20
Table 3-2-5 Parameters of WLAN Access Port
WLAN
Function description: Support WiFi function and provide wireless LAN access on site and
identity authentication of wireless user.
Parameters Description Default
SSID broadcast After turning on, use can search the WLAN via SSID name Enable
Mode
Six type for options: 802. 11g/n, 802. 11g, 802. 11n, 802.
11b, 802. 11b/g , 802. 11b/g/n
802.11b/g/n
Channel Select the channel 11
SSID SSID name defined by user inhand
Authentication
method
Support ope
n type, shared type, auto selection of WEP,
WPA-PSK, WPA, WPA2-PSK, WPA2, WPA/WPA2,
WPAPSK/WPA2PSK
Open type
Encryption Support NONE, WEP NONE
Wireless
bandwidth
Both 20MHz and 40MHz for selection 20MHz
Enable WDS Click to enable WDS Disable
Default Route Click to enable Route Disable
Bridged SSID Set bridged SSID None
Bridged BSSID Set bridged BSSID None
Scan Click “Scan” to scan the available AP nearby
Auth Mode Open type, shared type, WPA-PSK, WPA2-PSK Open type
Encryption
Method
Support NONE, WEP None
3.2.6 WLAN Client (STA Mode)
When working in STA mode, the router can access the Internet by connecting to access point.The
Router need to reboot after this operation.
Click the “Network>>WLAN Client” menu in the navigation tree to enter the “WLAN” interface.
Select “Client” for the interface type and configure relevant parameters. (At this moment, the
dialing interface in the "Network>>Dialing Interface" should be closed.)
The scanning function of the SSID is enabled only when Client is selected as WLAN interface. In
the “SSID scanning” interface, all available SSID names as well as the connection status of the
device as Client will be displayed.