User's Manual

20
5 Common usage and Examples
5.1 Base Configuration
Connect serial port 2 to the PC through a serial cable and power on the device.
Step 1: Launch and log into the DTU via configuration Tool.
Click <Connect>. In the pop-up dialog box, enter the user name and password (initial
user name and password are adm/123456). Select a serial port, set the serial port
parameters such as baud rate, and click <Connect>, as shown in Figure 5-1.
Figure 5-1 Login DTU
After a successful login, the device automatically reads the DTU parameters, and
then we can start to set the parameters.
Step 2: Set the local serial port parameters.
Ensure that the local serial port parameters are the same as the serial port
parameters of the device connected to DTU.