User's Manual

User Manual
85
6.7 SNMP
6.7.1 SNMP
At present, the SNMP Agent in ER800 supports SNMPv1, SNMPv2c, and
SNMPv3.

SNMPv1 and SNMPv2c use community names for authentication.
 SNMPv3 uses user names and passwords for authentication.
Method for enabling SNMP in ER800:
Click "Administration >> SNMP >> SNMP", check "Enable", select "v1c" or
"v2c" for "SNMP Version", and click Apply & Save.
If use v3c, you need also to configure corresponding user and user group. Enter
any name for "Groupname", select a security level, and click Add. Enter any
name for "Username", select the new group name for "Groupname", set
"Authentication" and "Authentication password", click Add, and then click
Apply & Save.