Quick Start Guide

MK8000 EVB Quick Start Guide
Mauna Kea Semiconductor Confidential
Rev 0.3
October 14, 2022
22 of 23
7. Reference
[1] MK8000 Datasheet v0.82
[2] MKTool User Manual v0.5
[3] ISP user manual v0.5
8. FCC regulatory compliance statement
§15.19 Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
§15.519(a) Statement
This device is approved under Part 15.519 for handheld use only
§15.21 Information to user
Warning: changes or modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
§15.212 and FCC KDB publication 996369 D04 Statement
This Module restrictions under limited modular certification in accordance with 15.212 and FCC KDB
publication 996369 D04.
(i)This Module complies with FCC radiation exposure limits must be such that there is a minimum
separation distance of 20 cm (or possibly greater than 20 cm) between the antenna radiating structures and
nearby persons. The host manufacturer is obligated to confirm the use conditions of the host product to ensure
that the distance specified in the instructions is met. In this case the host product is classified as either a mobile
device or a fixed device for RF exposure purposes;
(ii)Please notice that if the FCC and IC identification number is not visible when the module is installed inside
another device, then the outside of the device into which the module is installed must also display a label
referring to the enclosed module. For FCC, this exterior label should follow “Contains FCC ID:
"2A7T8MK8000UWBA”.
(iii) The Module comply with the antenna and transmission system requirements of §§ 15.203, 15.204(b) and
15.204(c).
The antenna is permanently attached to the module and cannot be removed without permission.
Labelling Instruction for Host Product Integrator
Please notice that if the FCC and IC identification number is not visible when the module is installed inside
another device, then the outside of the device into which the module is installed must also display a label
referring to the enclosed module. For FCC, this exterior label should follow “Contains FCC ID:
"2A7T8MK8000UWBA”.
FCC regulatory compliance statement (cont.)
§ 15.19 Labelling requirements shall be complied on end user device.
Labelling rules for special device, please refer to §2.925, § 15.19 (a)(5) and relevant KDB publications. For
Elabel,
please refer to §2.935.
Installation Notice to Host Product Manufacturer
The OEM integrator is responsible for ensuring that the end-user has no manual instruction to remove or install
module.
The module is limited to installation in mobile application, a separate approval is required for all other operating