User's Manual

Operation Instructions
1. Preparations before Use
1) Insert 2-AA batteries into your Outdoor Sensor.
2) Insert the 5 volt power cord into an outlet, then into your station. Optional: Insert
3-AA batteries for backup.
3) The LCD displays all for 3s, and emits 1 beep at the same time. After the backlight
is on for 3 seconds, it switches to the standard display mode, displays the
INDOOR ambient temperature, relative humidity, and atmospheric pressure.
4) Once the Outdoor Sensor is reading to your station, place it outside in a shaded
location.
5) The station will automatically display OUTDOOR temperature and humidity for 3
minutes RF long reception mode.
2. Power up
1) Hold the SET button for five seconds to enter settings SET. ENGLISH will show for language.
Press the + or – button if you want ESPANOL.
2) Press SET to select BEEP ON/OFF. BEEP ON will show. Press the + or – button to select BEEP
OFF and silence the beep when buttons are pressed.
3) Press SET to select ATOMIC ON/OFF. ATOMIC ON will show. Press the + or – button to select
ATOMIC OFF if you do not want the atomic time signal.
4) Note: If ATOMIC OFF is selected, you will skip Time Zone and DST settings and move 12/24
hour time.
5) Press SET to select Time Zone. ZONE EST will show. Press the + or – button to select a
different time zone. (AST=Atlantic, EST=Eastern, CST=Central, MST=Mountain, PST=Pacific,
AKT=Alaska, HAT=Hawaii)
6) Press SET to select DST On/OFF. DST ON will show. Press the + or – button to select DST OFF
if you do observe Daylight Saving Time.
7) Press SET to select 12/24 hour time format. 12H will show. Press the + or – button if you
prefer 24 hour time format.
8) Press SET to select Hours. The Hour will show. Press the + or – button to adjust the hour.