User's Manual

channel. The RF receiving mode is the same as the description, but it needs to receive 3
channels before turning off the RF receiving mode. After receiving the signal, the symbol
" " is displayed.
3) When the synchronization is turned on, the antenna symbol does not flash, it will be
displayed when it is received, and the display will disappear when it is not received
4) When the RF cannot receive the signal for 60 minutes continuously, the RF will automatically
enter the 3-minute long reception, but the ID number will not be cleared (when the
transmitter is powered on, it will randomly generate an ID number, the ID number is unique,
and the host can only receive the The ID transmitter will update the temperature), when the
ID signal is received, the outdoor temperature and humidity will be updated, and the RF
receiving mode will return to the original timing RF receiving time and mode. If the signal is
not received, the symbol " " will disappear. , Displayed as the last received value, and the
temperature and humidity values flicker every 3 seconds. At the same time, turn off the
synchronous RF receiving mode.
5) When the RF does not receive the signal for 120 minutes, the OUT temperature and
humidity displayed on the LCD will change to --.-and --, the system clears the original ID and
enters the 3-minute RF long reception, which can receive the matching product Any
transmitter signal (for example, it can be received after the transmitter is restarted). After
receiving, the outdoor temperature and humidity are displayed on the LCD, and the RF
receiving mode automatically enters the receiving mode every 1 minute. If no signal is
received, 1 Do not turn on the RF reception within hours, and automatically clear the ID
every 1 hour, enter the 3-minute RF long reception mode once until the signal is received,
and then switch to the reception mode of automatic code reception. If it still cannot be
received, the receiving mode will continue to loop (clear the ID for each long receiving) until
it is received, and then switch back to the automatic timing receiving mode after receiving it.
6) When the jumper is selected as 3CH, the RF receiving channel is 3CH, and the house marked
with OUTDOOR will display a value to indicate the channel.
7) When automatically or forcibly entering the RCC receiving mode and the alarm or
snooze-to-point alarm mode and time, the RF receiving mode is automatically closed, and
after the RCC receiving mode and the alarm mode are exited, the original synchronization
time per minute Click to enter the RF receiving mode again.
8) In the standard mode, press and hold the [DOWN] key for more than 2 seconds to turn off
the RF reception or turn on the RF long reception. When the RF long reception is turned on,
the ID of the channel is automatically cleared, and the displayed temperature and humidity
values are also cleared, and the display is- -.-℃ or --.-℉ and --%, turn on the RF 3 minutes
long reception again, and receive the signal again. After 3 minutes of long reception, the RF
reception is automatically turned off. If the signal is received, it will be automatically
received according to the function of automatic timing. If it is not received, it will be
processed as if the signal is not received.
9) In the standard mode, single press the [DOWN] key to switch the RF channel of OUTDOOR
(the function selects 3CH to be valid), after the conversion, the display shows the
temperature and humidity value of the channel
10) In the standard mode, press and hold the [DOWN] key for more than 2 seconds to turn off
the RF reception or turn on the RF long reception. When the RF long reception is turned on,