User manual

IDRS-6000S-HE Series PC Based DVRs user Manual

[Sensor Input(DI)] Display number of sensors (DI).

[Sensor output(DO)] Display the number of alarms(DO).

[Audio Monitoring] Select real-time monitoring audio or not

[Use E-Map] Select use Electron Map or not

[Camera sequencing interval] Set auto-split changing interval time.

[DI/DO Port] Select sensor/alarm driver connecting port, it must be different from PTZ

Port. If you do not use alarm input, you can close this function. To avoid conflicts to the

PTZ port, you should set and use the different ports for these two functions.

[System Keystroke] When it is enabling, functions of some system keys will be disabled

(Ctrl + Alt + Del included).

[Save Log for() Days] Log saves days(max 100 days).

[When disk is full] Select record mode when there is not enough HDD free space. If

selected “Overwrite data”, DVR system will delete the recorded data of the oldest day

automatically to free HDD space for new record. If selected “Stop recording”, DVR

system will stop recording and give a warning message

Notice:

Each disk will reserve 1000M space.

[Recording Disk] Select the first disk from which the DVR system saves data. The

previous disks of this one will not be used to record and it will not be checked by the

system. When the capacity of HDD is not enough or there has some mistakes while

recording, system will inform the failure of recording and the corresponding camera will

stop to record.

[Alarm camera popup interval] Set the interval of alarm camera, if you select “—”,you

can not select function “Start alarm popup”.

[DI/DO Device] Select receive alarm device type. When you change the type of alarm

device, you should reboot the system to update the device information in

DI/DO control

panel.

Note:

Note: Currently, system support following DI/DO devices: IDRS7608, IDSR7609,

IDRS7616, IDRS7616B, IDRS7632 and IDRS7632B. IDRS7632 includes two IDRS7616

(or combination of IDRS7608 and IDRS 7616), and IDRS7632B includes two

IDRS7616B. When you select these two selections you must set their decoder address

as 1 and 2, and they should connect with PC through RS 485 converter after they