User manual

IDRS-6000S-HE Series PC Based DVRs user Manual

2.2.3.6 Motion detection area & Cover setup

Press button to Motion detection area & Cover setup.

This function allow user to set the built-in motion detection.

By default, the entire screen is set as motion detection area where is indicated with

green border around the image. To mask a specific area, you can click

button to cancel the full screen detection border; then Left-Single-Click and drag a

rectangle. A green rectangle will mark the area of it. Also, you can set any other areas.

Any activities in the motion detection areas will trigger recording, depending on the

reaction mode; and alarms may be generated along with electronic map icons flashing in

alert mode. Click

button to test the sensitivity of motion detection. The

sensitivity can be adjusted by dragging the slider bar below the motion detection window.

Press

button to add mask. If there are some areas that you don’t want to show, you

can draw those areas with mouse till they change to be black. You can set several cover areas.

Press this button again to finish adding