User's Manual

7
6. Connection Configuration
HEV-10W supports both wired connection and wireless connection. Please note that
the IP of wired connection and wireless connection cannot be in the same network
segment. The default IP address of the HEV-10W is 192.168.1.251 (Wired) and
192.168.2.252 (Wireless in AP Mode). If you modify the IP address, please pay
attention not to set them in the same network segment.
6.1 Wired Connection
6.1.1 Change the IP Address of PC
The default IP address of the HEV-10W over wired connection is 192.168.1.251. In
order to connect to HEV-10W, please change the IP Address of PC to the same
network segment as the encoder. The specific instructions are as follows.
→ On a Windows PC: Press the +R on your keyboard.
→ Enter “control netconnections” in the run box and press “Enter”.
→You should see at least two types of network connections: Ethernet and WI-FI.
Double-click the active network connection.
→Select “Properties” and double click “Internet Protocol Version 4 (TCP/IPv4)”.
→Select Use the following IP address option and enter the IP address with
192.168.1.xxx (0-255 except 251) and Subnet mask 255.255.255.0. Press “OK”
twice to save the configuration.