User Manual

iX panel System Software
Note:
Whenupdatinganoperatorpanel,itis importanttoensurethatpowerisnot
interruptedduring thetransfer.
TransferprocedureinX2panels
The image transfer procedure is completely men u-driven. The operator panel
will be ready for transfer directly a fterwards, provided that all steps are performed
and completed.
The X2 panels can be updated either by using a USB flash drive, a recovery SD
card, or using the Ethernet connection to transfer the files.
Note:
X2basedoesnotsupportUSB flashdriveorSDCardupdates.
Transfer procedure using aUSBflashdrive
1.
Start the Image loader software on the computer.
2.
Plug an empty USB flash drive into the computer running the Image loader
software.
3.
SelecttheUSBflashdriveintheImageloadersoftware.
4.
Click Create.
5.
Disconnect power from the operator panel
6.
PlugtheUSBflashdriveintotheoperatorpanel.
7.
Reconnect power to the operator panel.
8.
Once the system files have been updated, any existin
g project in the panel will
be started.
Note:
Whenupdatinganoperatorpanel,itis importanttoensurethatpowerisnot
interruptedduring thetransfer.
Transfer procedure usingtheEthernetconnection
1.
Start the Image loader soft
ware on the computer.
2.
Select the operator panel to upgrade by entering its IP address.
3.
Click Update. Any project running in the panel will be stopped, and the
update sequence will begin.
4.
When the upgrade is finished, disconnect power from the operator panel.
5.
Reconnect power to the operator panel.
6.
Once the system files have been updated, any existing project in the panel will
be started.
BeijerElectronics, MAEN831P
357