User Manual

iX panel System Software
7.
Reconnect power to the operator panel.
8.
Once the system files have been updated, a project can b e downloaded to the
operator panel.
Note:
Whenupdatinganoperatorpanel,itisimportant toensurethat powerisnot
interruptedduring thetransfer.
TransferprocedureiniXTxB/iXT xBRpanels
The image transfer procedure is completely men u-driven. The operator panel
will be ready for transfer directly a fterwards, provided that all steps are performed
and completed.
The iX TxB panels can be updated either by using a USB flash drive, or using the
Ethernet connection to transfer the files.
Transfer procedure using aUSBflashdrive
1.
Start the Image loader software on the computer.
2.
Plug an empty USB flash drive into the computer running the Image loader
software.
3.
SelecttheUSBflashdriveintheImageloadersoftware.
4.
Click Create.
5.
Disconnect power from the operator panel
6.
PlugtheUSBflashdriveintotheoperatorpanel.
7.
Reconnect power to the operator panel.
8.
Once the system files have been updated, any existing pro
ject in the panel will
be started.
Note:
Whenupdatinganoperatorpanel,itisimportant toensurethat powerisnot
interruptedduring thetransfer.
Transfer procedure usingtheEthernetconnection
1.
Start the Image loader software
on the computer.
2.
Select the operator panel to upgrade by entering its IP address.
3.
Click Update. Any project running in the panel will be stopped, and the
update sequence will begin.
4.
When the upgrade is finished, disconnect power from the operator panel.
5.
Reconnect power to the operator panel.
6.
Once the system files have been updated, any existing project in the panel will
be started.
356
BeijerElectronics, M AEN831P