User Manual

iX panel System Software
If there is already a stored project in the target panel, the copy command will result
in a dialog asking if a backup of the existing project should be saved on the memory
card.
If IP settings are stored in the memory card, a dialog will appear, asking if the IP
settings should be applied to the target panel. It is necessary to reboot the panel for
the IP address to be updated.
The copy function can also be used to copy a project from a USB memory,
however without the possibility to transfer IP settings.
Touch Calibrate
Select To uch Ca li br at e if the touch screen needs to be calibrated. Follow the
instructions on the screen to perform a calibration.
Close
Press Close to exit the service menu.
22.3 iXpanelUpgrade
The operator panel can be upgraded using the Image Loader application.
22.3.1 Requirements
Updating of the operator panel system program requires the following:
• A PC with Image Loader application.
• An Ethernet connection between the PC and the operator panel.
• The operator panel IP address.
• TheImagefilefromthewebsite.
22.3.2 TransferImage
1.
Double-click on the executable Image Loader file to start the transfer program.
2.
Follow the instructions.
TransferprocedureiniXTxApanels
The image transfer procedur
e is completely menu-driven. The operator panel
will be ready for transfer d
irectly afterwards, provided that all steps are performed
and completed.
The following steps outline the transfer procedure:
1.
Disconnect the power supply from the panel.
2.
Press a finger on the screen and apply power
3.
Start the Image loader s
oftware on the computer, and follow the instructions
on screen.
4.
Select the operator panel to upgrade by entering its IP address.
5.
Click Upgrade.
6.
When the upgrade is finished, disconnect power from the operator panel.
BeijerElectronics, MAEN831P
355