User Manual

iX panel System Software
22.2.2 ServiceMenu iniXTxA/iXTxB/iX
TxBR/X2base/X2control/X2
motion/X2marine/X2proPanels
Perform the following steps to enter the service menu:
1.
Apply power to the panel.
2.
When the hourglass appears, press a finger on the screen and hold for
approximately 20 seconds.
3.
If the service menu is password protected, you will be prompted for a pin code.
Enter pin code.
4.
The touch calibration screen will display the following message:
“Tap anywhere on screen or touch calibrate will start in 10 seconds.”
5.
Press finger once again to enter the service menu.
22.2.3 ServiceMenuOptions
The service menu is only available in English.
IPSettings
Select to obtain an IP address automatically via DHCP, or specify an IP address.
The IP address can also be set during project transfer.
For panels with two Ethernet ports, select port according to the illustration below.
The por t that is currently connected is r
ecognizedbya*.
Date/Time
Use the Date/Time Settings dialog to set the time zone, date and time for the
panel.
EraseProject
The erase function will detect if the project is located in the panel memory or on a
memory card. PressingErase Project will completely remove the project and all its
components from the panel memory/the memory card.
CopyProject
Selecting Copy Projectwill copy a project from a connected memory card to the
panel memory.
354
BeijerElectronics, M AEN831P