User Manual

Ribbon Tabs
Export
Exports the project to a folder which is selected by the user.
When expor ting the project, the user might be prompted whether the panel IP
settings should be set. If yes, the Ta rget Se tti ngs dialog is opened.
Assigning IP settings is only supported for iX Tx A, iX TxB , X2 base, X2 control,
X2 motion, X2 marine and X2 pro targets.
ExportingaProject to anoperatorpaneloraPCw
ith
iXRuntimeInstallation
A project can be exported to an operator panel or a PC with an iX Runtime
installation via the Export command. The project can be exported to a USB stick
or, on t he condition that a network connection is configured, directly to a folder in
the runtime PC.
The project in the runtime PC is started by running the .exe file located in the
project folder.
There will also be aTransferClient.exe file, which is a standalone application for
downloading the exported project to a target. Executing the TransferClient.exe
file will open the Download dialog. It is possible to view a log for the export by
clicking the Log button on the Download dialog.
Note:
Itisnotrecommended
tohandlefurtherprojecttransfersfromaPCalreadyusedas
atargetforexport.
Ifadditionaltransfersaretobe done, thenkeepusingthe same
exportmethod foral
l.
Relatedinformation
Download
Starting an i
X Runtimeproject on aPC
BeijerElectronics, MAEN831P
229